Its-My-Blog.com

There are two main types of mixer showers or mixer valves available, the first type lam going to discuss is the buried valve type. A buried valve mixer shower is the type where the valve is buried into the wall. I have come across a few problems with this type of mixer valve. One of the biggest problems with this shower is in the installation. When installing a buried valve shower you have to cut a hole into the brick work to accommodate the valve.

Some of these showers need a 100mm deep hole, this is not a problem if you are fitting the shower to an external wall because the wall is a double brick coarse which is at least 250mm thick. The problems start when you try and fit one of these showers to an internal wall which is only 100mm thick single coarse. When you are cutting the hole there is a good chance of going straight through the wall into the next room. If you are planning to buy one of these showers check the wall that you plan to mount the shower on and also check how deep the shower valve is.

The other problem is when the shower is buried it is hard to repair if it goes wrong, on some models the tiles around the shower would have to be removed to gain access to the vale.
The best option in my opinion is to use a surface mounted valve as apposed to the buried valve type, there is a lot less problems with the installation and they are a lot easier to replace or repair if things go wrong. Triton showers make both types of mixer showers and a couple of the Triton showers models have the option to be surface mounted or buried.

Showers for areas with low water pressure.
If you are unlucky enough to live in a area where the mains cold water pressure is to low for an ordinary electric shower unit, and you don’t have a combination boiler fitted, then the options for a shower are limited to two types of shower.
Option one is an electric power shower, this is a shower with a on board pump. The only problem with an electric power shower is that they don’t heat there own water, the unit relies on the stored hot water that is produced by the immersion tank or boiler. If you have a large family and the shower is in daily use then this can be a problem. After the shower has been used a couple of times the hot water will run cold, and you will have to wait for the water in the immersion heater to reheat before you can use the shower again.

The other option is a pumped electric shower, pumped electric showers operate on the same principle as an ordinary electric shower, in the sense that they heat there own water. This type of shower will not run out of water and the pressure will be constant as there is an on board pump that is fed from a tank in the loft or attic. This type of shower is ideal for low water pressure areas and for every day use.

The installation is exactly the same as an electric shower, but the plumbing side is a little different. If you are going to buy one of these showers have a qualified electrician carry out the electrical work and a plumber to do the plumbing work.

Fetch pragmatic things to know in the sphere of internet marketing – please read this publication. The time has come when proper information is really only one click away, use this opportunity.

Technorati Tags: Apposed, Brick Work, Cold Water Pressure, Combination Boiler, Deep Hole, Double Brick, Good Chance, Low Water Pressure, Mains, Mixer, Models, Option One, Shower Valve, Tiles, Triton Showers, Valve Type

When your toilet won’t flush properly, it may be because you have a foreign object stuck in the drain. Before considering the list of common foreign objects, it is worth noting several other common causes of clogged toilet drains. You can start by checking if there is water in the water tank. Lift up the top and take a look. If the water is low, you can at least dump bucket water into the tank. This will provide one good flush so you can at least work around a clean bowl. Your problem might be caused by a broken toilet lever. You can test this by pushing down on the lever, and observing the action. A cracked diaphragm or siphon in the toilet water tank is another common cause of inability to flush the toilet. The siphon normally lifts up the water, at the start of the flush, initiating the flush action. If the siphon is cracked, the toilet won’t flush properly. Finally, inability to flush the toilet may be the result of low water pressure in the house. It could be that the pressure is insufficient to push enough water up to the water inflow valve.

With all that said, a clogged toilet is frequently the result of a foreign object in the drain. The numbers of foreign objects that can block a toilet drain are myriad. Some of the more common items include lady sanitary napkins and baby wipes. Whole rolls of toilets, frequently dumped in by mischievous kids can block toilets from flushing properly. Other items that kids toss into toilets include toys, a child’s comb or hairbrush. Just about any small item in a young child’s possession can end up in the toilet bowl. A 2 year old once tossed the splash shield from his potty chair down the toilet and this caused a serious blockage.

Kids are not to blame for all or most foreign objects. Adults will not infrequently place objects on the lid of the toilet water tank, or even on the toilet seat, and then accidentally knock the object down the drain. An example of one such foreign object was the powder makeup compact case that a lady had knocked down the toilet with her elbow. Finally, too much human waster can also cause toilets to clog; as one man sheepishly put it: “I completely blocked up my toilet after eating my burrito from Applebee’s.”

If your toilet is clogged, and you think it might be due to a foreign object, there are a couple of procedures you can try before calling the plumber. You can use a plunger to try and dislodge the foreign body with pressure, or you can insert a carefully straightened out coat hanger, to see if this will dislodge the foreign object.
Most foreign objects take up residence behind the ubend in the toilet drain pipe, and frequently require more extensive procedures to be dislodged.

Thanks to A-1 Plumbing of Baltimore for sponsoring this article. If you are having problems with a clogged toilet and were unable to fix the problem yourself, then call a plumber. If you live in the Greater Baltimore Area, or surrounding communities, as far south as DC, give us a call, and we will send out a radio dispatched plumber to tend to your problem.

Read practical information about local search optimization – dig into hyperlinked web page.

Technorati Tags: Baby Wipes, Bucket Water, clogged toilet, Comb, Diaphragm, Drains, Low Water Pressure, makeup, Mischievous Kids, Possession, Potty Chair, Sanitary Napkins, Splash Shield, Toilet Bowl, Toilet Drain, Toilet Seat, Toilet Water, Toilets, Water Inflow, Water Tank