Archive

Posts Tagged ‘electric clothes dryer’

Heat Recycling Using Electric Clothes Dryer

November 25th, 2009 Blog Writer No comments

Due to the fact that the cost of electricity rises more and more each day, users are looking for innovative ways to help get the most benefit out of their widgets. One of them is the electric dryer.

Although the intake cannot be taken down, there is a gagdet to benefit from the heat which it produces. This twist is a dryer heat recycler. It has proven the bestfighting against spending overmuch energy.

A heat recycler does exactly what its name indicates. It redirects the hot air coming from the house electric clothes dryer back into the laundry room. If your laundry room is in a cold cellar this is a supplemental bonus and the heat is free.

It is so simple to explain the way the recycler works. It utilizes the hot air from the electric dryer to heat the laundry room which involves that there is no need the room vent is open. Therefore, this brings down your heating prices. Hence, the air that you usually dumps outside could be redirected into the house, and all this for the price not greater than $15. Plastic handle is used for that. During winter the handle is set to direct the hot air into the house while during summer it directs the air back outside.

The heat recycler installation is performed very easy. Normally, it is raised to a wall after which it might be cut and reattached to the gadget, or beam behind, and slightly above the electric dryer console area. Make sure you put it on easy accessible places; or, no one will clean the filter. Follow the hints to sustain proper airflow direction.

If you make a decision to get it, make sure the type you have taken contains two venting clamps. It might happen that some low-cost types don’t contain the clamps, what is a crucial thing for a proper installation. Do not bind the venting parts to the recycler with duct tape because it can dry out and make the venting fall off.

There is a built-in filter screen in the recycler which has to be cleaned just as the one inside the electric dryer. We prefer the type that has a mesh screen filter contrary to the one with a sock-like filter. It is just two dollars more, but the metal filter can be used more times and it is a great deal simpler to clean than the cotton type.

After you have set the recycler let it operate so as to test it. Let the temperature selector is adjusted to hot and start dryer. Let it work a couple of minutes. Test whether the air comes inside when the handle is in the winter position, and then change the handle to summer mode. Go out of the house and ensure that air is freely released outdoors. If it doesn’t go, it might be as the screen in the outdoor vent is blocked with lint, or due to the fact that the vent cap flapper valve may be sticking. In that case, try all joints for air leakage. If there is a leak, tape joints with duct tape.

You are next required to clean the heat recycler filter every few washing loads. Moreover, turn the handle so as to change the direction of the air flow twice per year. As you have already seen, I use the term electrical clothes dryer. It is not possible to apply the heat recycler with a gas clothes dryer. The venting pipe of a gas dryer should not be opened or redirected. There may be small amounts of gas vapor in the electric outlet air of a gas clothes dryer. Hence, keep always in mind that the heat recycler cannot be used with a gas dryer.

Technorati Tags: , , , , , , , , , , , , , , , , , , , , , ,

Can You Save Energy With Electric Clothes Dryer?

November 18th, 2009 Blog Writer No comments

Each costomer enjoys using the appliance that functions well and saves energy simultaneously. It is great for the environment and your budget, also. One of these gadgets is the electric clothes dryer and here are a few helpful points of how to save electricity when using it:

It is very significant to clean the dryer lint filter after each load, as it is surely a good way to keep energy. Although there is a small amount of lint on the filter, it can restrain the flow of air, causing the dryer to run longer.

If your dryer has an Auto Cycle, be sure to use it correctly. The auto cycle recompenses for the size and kind of material that is being dried. The drying time will be set up to make sure the clothes get dry as soon as possible. There is no doubt that energy will be saved that way.

You are advised to clean the electric clothes dryer venting once per year. Lower the venting and clean out any lint created. Besides, there may be some lint picked up in the venting cap, and so ensure you clean that, as well. Any venting restraint will slow down air flow, which, as a result, slows the process of drying clothes, and increases the period involved for the clothes to get dry.

If too many anti static sheets are used in the electric dryer at one time they may block the lint filter. This may restrict air flow and cause the dryer to overrun and work too much time. Thus, take the old ones from and then add new ones.

Take into consideration a front loader when it’s time to change the washer. A high speed is needed to spin it, which removes a lot more moisture than the top load style. Hence, your clothes will dry out more promptly. The common time for drying of 60 minutes falls to 30 minutes when a front load washer is utilized.

If after each load a large quantity of lint is found at the door seal, then you should buy a new door seal. You can check that by letting the dryer run with full load of clothes. Air and heat may get past the seal and you could check that with your hand around the closed door area. If you feel any air stream, the door seal should be changed.

After some time, the housing which holds lint filter may be covered with old lint. This restricts air flow and wastes energy. In that case remove filter (first switch off dryer from electricity, or turn off breakers), and and clean lint buildup with a vacuum cleaner or narrow brush.

If it comes about that your electrical energy supplier charges less occasionaly throughout the day, take into consideration letting your dryer operate during more cheaper periods of time. Most corporations charge lower rates after 8:00 pm. You can certainly save eletricity, if your clothes dryer works after this time in the night. Nevertheless, just to be on the safe side, you shouldn’t run the dryer, if you need to leave the house or you are asleep.

All clothes dryers begin their life as very economic. Just, in a while their efficiency goes down totally. So as to keep that longer, these machines should have some standard maintenance. Thus, if the clothes come out wet, or the machine becomes too noisy, consult an expert. As a matter of fact, you may best keep energy by adopting the previously mentioned hints, and make sure there is the least lint as possible.

Technorati Tags: , , , , , , , , , , , , , , , , , , ,

Reapairing A Broken Electric Dryer

November 10th, 2009 Blog Writer No comments

It is certain that clothes dryers are one of the most usable electrical appliances which have ever been produced. It is a perfect solution for those individuals who live in upper level apartment buildings and have not chance to just hang their clothes outside on a line. Still, after after time goes by the clothes dryer will begin to have problems, when you will have to know a little bit how to deal with it.

Firstly, if your clothes dryer still has a guarantee, you should not take any risk in trying to work it on your own. You have to get through the company which will send a repairman to come and see what is wrong with the dryer. Most warranties claim that if you make effort to work the clothes dryer by yourself you might make the warranty invalid. Thus, if you open the top or the back, you can finish giving the money for all the parts. Providing that your clothes dryer is past its warranty, you could repair it alone. Most of it is easy.

If your clothes need more time to dry than usually, the reasons can be various. Hopefully, you did not discard your owner’s manual, because it is one of the most significant booklets that you could ever receive about the trouble shooting that from time to time occurs with your clothes dryer. First, check if the lint filter is cleaned on a regular basis at least once a week.

If there is no problem with the filter, the next thing to look into is your vent tube. It may occur that it has been stopped by something so you should clean it out. In that case you need to disconnect the dryer and put it away from the wall, as then you are able hold it from the back. The hose (tub) will only let you move the electric clothes dryer for a short distance. Then, with a pair of channel locks, if it uses a clamp of that time to apply the hose onto the base, it may require a screwdriver, or a pair of pliers to let the hose. When the hose is up, you can check down into it as far as you could, or you can shake it to find out if there could be some rubbish somewhere in the hose itself.

If it is not the case, consultcheck the owner’s manual on what you are supposed to do next. It is really simple to take the back off the clothes dryer but, be very alert with the sharp edges on the cross plates which, even they are dull, might cut you sometimes very badly. Once you see the heating unit, you will see that you will have to unplug some wires. In that case it is really crucial to find out which wires to put in which place, as otherwise you may cause an electrical fire. On the inside of the plate you will note some screws or nuts which have been fastened. It may be troublesome to free them so that they will turn easy; still, once you separate the unit you must take it to the accurate facility.

And this is the end. There are other items, like the belt and the motor, but there isn’t enough space in this article to delve into those areas. However, it is suggested that you find out as much as you can about repairing your clothes dryer.

Technorati Tags: , , ,

Page optimized by WP Minify WordPress Plugin